![Ponyprog usb to serial](https://kumkoniak.com/75.jpg)
NOTE: in this case COM 4 (Serial TTL port) will be occupied by the Dynamix. Servos will be connected to the 3 pin (white) connector. Power will be connected to the external power supply (see servo manufacturer recommendations). (the other remaining channels can be used independently in various modes, and the same port can only be used for one interface at the time) USB to PonyProg adapter – in this mode the COM2/second channel is configured as a Pony Programmer interface.USB to I2C interface – in this mode the COM1(3.3V levels) or/and COM2(5V levels) are configured as an I2C standard interface.USB to JTAG interface – in this mode the COM2/second channel is configured as a JTAG interface(5V levels).USB to SPI interface – in this mode the COM2/second channel is configured as a SPI interface(5V levels).USB to Dynamixel adapter – in this mode the COM4/forth channel is configured as a Dynamixel interface(3 pins).
#PONYPROG USB TO SERIAL SERIAL#
![Ponyprog usb to serial Ponyprog usb to serial](http://electronics-diy.com/schematics/avr_programmer/avr_programmer_schematic.jpg)
The USB adapter’s drivers make it seem like a standard serial port to the operating system, allowing you to connect to all of your existing software, such as servo controller interface programs via USB port. used in a large variety of applications from robotics to industrial and medical. It can be used also as a Dynamixel controller in projects that involve driving a servo and/or collecting signals from different modules such as a Sonar Range Finder, Compass, GPS modules, Barcode scanners, RFID readers, etc. The USB to 4 serial ports adapter is great for connecting micro controller projects to a personal computer.
![Ponyprog usb to serial](https://kumkoniak.com/75.jpg)